Tuesday 26 December 2017

Post #4 (delayed!!) - Bodies Start Coming Together

Opps... It is now November , 2018 and I opened up my blog to make a new entry. Discovered that I had failed to press the "publish post" button and this post has sat dormant for the last year.
This now explains the queries from my thousands of followers, (3 to be truthful) asking "when are you going to add to your blog?" - well better late that never - so here it is!      Now onto Post #5.

There was a 4" strip between sections
Lifted top with old camper jacks
Removed the top of the 4 dr. by drilling out the spot welds and  cutting the "A" and "B" pillars.

Cut out the 4 inch joiner strip between body sections.

 
Shortened bodies put on 2 dr. frame.
Body sections tack welded


Positioned the two body sections on the rebuilt 2 dr. frame.

Bolted them to the frame and tack welded them together.




                                                                                                                                                                             
Cut off top and quarters and lifted off
 Removed the top of the 2 dr. complete with the rear quarter panels still attached.

Got remains of the 2 dr. body onto my boat trailer and  rolled it out of the garage.

Rolling chassis under top
Top in position for closer cutting
What a treat.. had whole garage again! Now got the 2 dr top and quarters on body for final cutting and fitting.
Took it on and off a few times to get it how I wanted it.
Put fender on for check of fit and saw that my body is 1/4" too long!
Not a problem - only tacked together.
Taking it apart one final time for cleaning in prep for welding and will shorten it at that time.
Separating for final time
Should be no gap!


Took sections apart for what I hope  is the final time. I need to clean joints for welding.

Will cut off 1/4" from mid-section also at the same time.



Windshield spline
Maneuvering to get splines inserted.
Fabricated some splines for the windshield pillars to add strength and make it easier to weld.

These splines were needed but made the final install of top quite difficult.

Managed to spread the quarters very wide and force them over the wheel wells to get all the right angles so splines would go into windshield pillars.


Now in final position and awaiting welding in place.
Taking a break for a nice Hawaiian vacation and for the busy Christmas Holiday Season.
If you visit my photo album link at the top of the page there are  more pictures that will help you make sense of all this.



Hope everyone has a Happy Holiday Season

Drop over for a beer anytime and see what is really happening!

As many of you know already the joy of retirement is that every day is a holiday!!
Have a good one..... Ron Cann Sr.